Drill press table

Finally I have a good looking table for the drill press.
DSC_0042

DSC_0009

DSC_0010

Two points form a line. It needs only three points to form a plane and leveling surface of plane by adjusting height of each point. I used a compass and protractor to draw a equilateral triangle on the circumference of inner circle. And I used the vertices of the triangle for drilling three holes to mount the top plate.
DSC_0014

Leveling of the top plate is done by turning the three nuts under it.
DSC_0016

Wooden drill bit holder.
DSC_0045

Fine example of recycle leftover materials: a piece of cardboard, A4 paper, wooden block, broken wooden pieces.
DSC_0047

DSC_0053

DSC_0059

About janpenguin

Email: janpenguin [at] riseup [dot] net Every content on the blog is made by Free and Open Source Software in GNU/Linux.
This entry was posted in DIY and tagged , , . Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s