Category Archives: DIY

Removal of an old navigator on Honda Civic 2.0

When I bought the 2007 Honda Civic 2.0 few years ago, it had an old navigator with rear view camera. I have been using it as rear view camera only because the navigator app is better. Tools and material: Trim … Continue reading

Posted in DIY | Tagged , , , | Leave a comment

Install bigger battery on 2007 Honda Civic 2.0

I installed a bigger batter than stock one to my 2007 Honda Civic 2.0. In common sense the production cost of smaller battery is less than big one provided they use exact same technology and material. The battery manufacturer charges … Continue reading

Posted in DIY | Tagged , , | Leave a comment

High Temperature Resistance Magnets

https://www.first4magnets.com/high-temperature-resistance-magnets-t162 ‘SH’ grade neodymium magnets operate up to 150 degrees celsius Ferrite magnets operate up to 180 degrees celsius Samarium cobalt magnets operate up to 300 degrees celsius https://www.stanfordmagnets.com/ndfeb-magnets-temperature-ratings.html Temperature Effects on Neodymium Iron Boron, NdFeB, magnets The NdFeB magnets … Continue reading

Posted in Reprap 3D Printer | Tagged , , | Leave a comment

Steel plate from Trianglelab

I cleaned surface of the plate with acetone. I use four neodymium magnets to secure the steel plate on heated bed.  

Posted in Reprap 3D Printer, Uncategorized | Tagged , | Leave a comment

Photo light box

3D Printed parts https://www.thingiverse.com/thing:3905512

Posted in DIY, Photography, Reprap 3D Printer | Tagged , , | Leave a comment

Headlight bulb replacement of 2008 Ducati Monster 696

H7 light bulb: 12V 55W Remove the two M10 nuts Take off the headlight assembly from the steering bar.    Remove the five screws of the cover using Philips drivers Remove the screw, retainer, and old headlight bulb Install new … Continue reading

Posted in DIY, Motorcycle | Tagged , , , , | Leave a comment

Rear plate bending of Prusa i3 MK3

Posted in Reprap 3D Printer | Leave a comment

Fine tuning of Z height at zero

Printed first layer of the model has to smaller than equal to the first layer height in slicer.   After upgrading MK2S to MK2.5S, I did fine tuning of Z height at zero by measuring the thickness of first layer. I … Continue reading

Posted in Reprap 3D Printer, Uncategorized | Tagged , , , , | Leave a comment

ZATSIT 3D Printer kit

http://www.zatsit.fr/store.html

Posted in Reprap 3D Printer | Tagged | Leave a comment

Heat sink leakage of E3D V6 Hotend

On May 2018, I replaced 0.4 mm nozzle with 0.8 mm Volcano nozzle.  Two days ago my Prusa i3 MK2 started to develop non-stop printing failure. Slic3r setting could not solve the issue. Last night I noticed that the idler … Continue reading

Posted in Reprap 3D Printer, Uncategorized | Tagged , , | Leave a comment