Tag Archives: DIY

Removal of an old navigator on Honda Civic 2.0

Posted on May 31, 2021 by janpenguin

When I bought the 2007 Honda Civic 2.0 few years ago, it had an old navigator with rear view camera. I have been using it as rear view camera only because the navigator app is better. Tools and material: Trim … Continue reading →

Posted in DIY | Tagged , , , | Leave a comment

Photo light box

Posted on November 8, 2019 by janpenguin

3D Printed parts https://www.thingiverse.com/thing:3905512

Posted in DIY, Photography, Reprap 3D Printer | Tagged , , | Leave a comment

Headlight bulb replacement of 2008 Ducati Monster 696

Posted on June 22, 2019 by janpenguin

H7 light bulb: 12V 55W Remove the two M10 nuts Take off the headlight assembly from the steering bar.    Remove the five screws of the cover using Philips drivers Remove the screw, retainer, and old headlight bulb Install new … Continue reading →

Posted in DIY, Motorcycle | Tagged , , , , | Leave a comment

Voron 3D Printer info

Posted on March 23, 2019 by janpenguin

RAMPS 1.4 board: Zyltech Arduino Mega should have 16U2 USB controller.

Posted in Reprap 3D Printer, Uncategorized | Tagged , , , | Leave a comment

Pipe cloth hanger

Posted on May 17, 2018 by janpenguin

https://www.thingiverse.com/thing:2916220  

Posted in DIY, Motorcycle | Tagged , , , | Leave a comment

Remote key battery replacement of 2007 Honda Civic

Posted on October 23, 2017 by janpenguin

It requires a small Philips driver to loose one screw. The battery is CR1616 3V.

Posted in DIY, Uncategorized | Tagged , , , , , | Leave a comment

Reverse Bleeding Clutch or Brakes On Motorcycle

Posted on April 26, 2017 by janpenguin

This method will save time and money. Special tool: DIY pressure pump – big syringe, clear tube, right angle connector

Posted in DIY, Motorcycle | Tagged , , , , | Leave a comment

Home-made desk upgrade

Posted on April 12, 2017 by janpenguin

Link of the design file is here.

Posted in DIY, Reprap 3D Printer | Tagged , , , , , | Leave a comment

DIY structured water device

Posted on March 24, 2017 by janpenguin

 

Posted in Health | Tagged , | Leave a comment

Steel Fisher is running like a tank.

Posted on September 26, 2016 by janpenguin

So many story to tell about Steel Fisher. One year ago I bought Fisher Beta kit from RepRapPro Ltd. To lower cost of the kit, the designers used laser cut acrylic parts from frames to core components. Effector was made … Continue reading →

Posted in Reprap 3D Printer | Tagged , , | Leave a comment