Tag Archives: Hydraulic press

2 ton press station for steel pipe

Reference photos for the upgrade.

Image | Posted on by | Tagged , , , | Leave a comment

Journal of 2014/7/01

2014/07/03 2014/07/01 Type E and D struts are done. I managed to press twenty struts afternoon today. Average time of pressing a pipe’s mouth was six minutes which was little slower than I thought. I had to fix minor issues … Continue reading

Posted in DIY | Tagged , , , , | Leave a comment

Journal of 2014/06/27 – 2 ton hydraulic press

This is the third version of hydraulic press I’ve build so far. Finally I have the hydraulic press exclusively for pipe work. I will fix few glitches I found it today but the priority is to flatten the dome struts … Continue reading

Posted in DIY | Tagged , , , | Leave a comment

Journal of 2014/06/25

Biggest drill bit I have is 12 mm. To make a 22 mm hole for the press rod guides, I made a hole at the center with 12 mm bit, then drilled many 3 mm holes around it, used square … Continue reading

Posted in DIY | Tagged , , , | Leave a comment

Journal of 2014/06/19

The two days of work started at 5:30 AM on Wednesday, finished at 8:00 AM on Thursday June 19th, 2014. I rented a hydraulic press called ‘Brick Cutter’ from a tool rental / repair shop on Wednesday morning for 30,000.00 … Continue reading

Posted in DIY | Tagged , , , , | Leave a comment

2 ton hydraulic press

On Friday of last week the brand new jack got broken. I bought it for 38,000 KRW on April 2014. I thought it would few years becasue it is domestic product. I found the above setup has serious design flaw … Continue reading

Posted in DIY | Tagged , , | Leave a comment

3 ton hydraulic press

Parts: Hydraulic automotive jack – rating 3 ton Four threaded rods – 18 mm in diameter Sixteen bolts – 18 mm in diameter Washers – 20 mm in diameter Two Springs (Need to buy) The grinding bit almost exploded. The … Continue reading

Image | Posted on by | Tagged , , | Leave a comment