Category Archives: Reprap 3D Printer

RepRap (http://reprap.org/wiki/RepRap) 3D Printer

High Temperature Resistance Magnets

https://www.first4magnets.com/high-temperature-resistance-magnets-t162 ‘SH’ grade neodymium magnets operate up to 150 degrees celsius Ferrite magnets operate up to 180 degrees celsius Samarium cobalt magnets operate up to 300 degrees celsius https://www.stanfordmagnets.com/ndfeb-magnets-temperature-ratings.html Temperature Effects on Neodymium Iron Boron, NdFeB, magnets The NdFeB magnets … Continue reading

Posted in Reprap 3D Printer | Tagged , , | Leave a comment

Steel plate from Trianglelab

I cleaned surface of the plate with acetone. I use four neodymium magnets to secure the steel plate on heated bed.  

Posted in Reprap 3D Printer, Uncategorized | Tagged , | Leave a comment

Photo light box

3D Printed parts https://www.thingiverse.com/thing:3905512

Posted in DIY, Photography, Reprap 3D Printer | Tagged , , | Leave a comment

Rear plate bending of Prusa i3 MK3

Posted in Reprap 3D Printer | Leave a comment

Fine tuning of Z height at zero

Printed first layer of the model has to smaller than equal to the first layer height in slicer.   After upgrading MK2S to MK2.5S, I did fine tuning of Z height at zero by measuring the thickness of first layer. I … Continue reading

Posted in Reprap 3D Printer, Uncategorized | Tagged , , , , | Leave a comment

ZATSIT 3D Printer kit

http://www.zatsit.fr/store.html

Posted in Reprap 3D Printer | Tagged | Leave a comment

Heat sink leakage of E3D V6 Hotend

On May 2018, I replaced 0.4 mm nozzle with 0.8 mm Volcano nozzle.  Two days ago my Prusa i3 MK2 started to develop non-stop printing failure. Slic3r setting could not solve the issue. Last night I noticed that the idler … Continue reading

Posted in Reprap 3D Printer, Uncategorized | Tagged , , | Leave a comment

3D Printing Station – 4

This gallery contains 12 photos.

More Galleries | Leave a comment

3D Printing Station – 3

Posted in Reprap 3D Printer | Leave a comment

Voron 3D Printer info

RAMPS 1.4 board: Zyltech Arduino Mega should have 16U2 USB controller.

Posted in Reprap 3D Printer, Uncategorized | Tagged , , , | Leave a comment