Tag Archives: workbench

Journal of 2014/11/10

Checking the level of six vertices that forms one flat plane. Making three cross bars that support two wooden plates. Drilling nine bolt holes that attach three cross bars and two plates on top of the workbench. Checking alignment of … Continue reading

Posted in DIY | Tagged , , , , , , , | Leave a comment

Journal of 2014/11/07

Ninety minutes of resurfacing work barely made one third of the lumber surface flat. I made a straight cutting jig. Parts: 2020 Aluminium extrusion M4x12 cap screw x3 M4 T nut x3 M3 Philips screw x3 40mm x 40mm, 2mm … Continue reading

Posted in DIY | Tagged , , , , , , , | Leave a comment

Journal of 2014/11/05

Installation of foot switch on the drill press is done. Replaced tape wraps and strings with wire connectors, zip tie strips, and a plastic tube. Upgraded the wood lathe Redesigned claws of the drive center which has six small claws … Continue reading

Posted in DIY | Tagged , , , , , , , , | Leave a comment

Journal of 2014/10/26

The capacitor of the drill press – Rexon DP-200A. I did simple milling experimentation on the drill press. I’ve learned that drill press can be used to do light milling operation. One expert suggested that milling ten thousandth of inch … Continue reading

Posted in DIY | Tagged , , , , , , | Leave a comment