Tag Archives: temperature

Mastering bridge

Posted on July 9, 2015 by janpenguin

I performed E steps fine tuning. The original E steps was 462.80. Final E steps became E443.09 going through eight to ten calibration objects. Infill 95%, Solid layer Solid layer, Infill 95% E Steps Fine Tuning Now, with everything very … Continue reading →

Posted in Reprap 3D Printer | Tagged , , , , , | Leave a comment

PLA vs ABS tough or not ?!

Posted on October 20, 2014 by janpenguin

Source: http://forums.reprap.org/read.php?1,420767 Rigor_M [ PM ] PLA vs ABS tough or not ?! October 17, 2014 07:32AM Registered: 1 year ago Posts: 86 Ok, So I guess this topic was discussed multiple times on this forum but still, I can’t … Continue reading →

Posted in Reprap 3D Printer, Science and technologies | Tagged , , , | Leave a comment

How to control CPU frequency?

Posted on August 10, 2012 by janpenguin

When CPUs run in full throttle for certain amount of time, temperature of CPUs increase gradually until it shuts down the system for destroying itself. My Linux desktop has AMD Athlon(tm) 64 X2 Dual Core Processor 4800+. It’s operating temperature … Continue reading →

Posted in GNU/Linux | Tagged , , , , , , , , , , , | Leave a comment

How to build a humidity meter.

Posted on May 23, 2012 by janpenguin

I need to measure humidity for practicing permaculture. I saw two humidity meters at a local shop. The price range were $20 to $15. I thought I would build it by myself. To build a humidity meter is relatively easy. … Continue reading →

Posted in Permaculture, Science and technologies | Tagged , , , , , , | Leave a comment