Tag Archives: first layer

Fine tuning of Z height at zero

Printed first layer of the model has to smaller than equal to the first layer height in slicer.   After upgrading MK2S to MK2.5S, I did fine tuning of Z height at zero by measuring the thickness of first layer. I … Continue reading

Posted in Reprap 3D Printer, Uncategorized | Tagged , , , , | Leave a comment

First layer of the printing object is so critical.

I play in the ten micron (0.01 mm) world. I’m so close to finalize Bulbul Junior 3D Printer but apparently there is one issue I have to solve, which is the Z height changes after few printing session. I suspected … Continue reading

Posted in Reprap 3D Printer | Tagged , , , , , , , , | Leave a comment

How to produce good first three layers?

I’m so close to the level of printing quality from Bulbul Junior. One last thing I need to solve is thin first three layers.

Posted in Reprap 3D Printer | Tagged , , , | Leave a comment