Tag Archives: ABS

Fine tuning of Z height at zero

Printed first layer of the model has to smaller than equal to the first layer height in slicer.   After upgrading MK2S to MK2.5S, I did fine tuning of Z height at zero by measuring the thickness of first layer. I … Continue reading

Posted in Reprap 3D Printer, Uncategorized | Tagged , , , , | Leave a comment

Imperfection of 3D printing ABS filament

How to prevent the slack of inclined side? Filament: eSun ABS Printing temperature: 255C

Posted in Reprap 3D Printer, Uncategorized | Tagged , , , , , | Leave a comment

E3D Volcano hotend Slic3r settings

(3/24/2019) I made change on Slic3r settings. All extrusion widths are 0.8mm except First Layer is 0.9 mm. Extrusion multiplier is set to 1.174 for getting rid of tiny gap between walls. The wall thickness during calibration started at 0.76mm, … Continue reading

Posted in Reprap 3D Printer, Uncategorized | Tagged , , , , , , , | Leave a comment

Bookshelf speaker stand

Chario Reference 100 The design file is here.

Posted in DIY, Uncategorized | Tagged , , , , , | Leave a comment

Original Prusa i3 MK2 – ongoing review

Installed granite base (02/08/2017) Dimension of the granite plate: 400x400x30 mm Weight: 13 kg (2.75 g/cm^3) It dampens vibration and reduces noise. 10/20/2016  PINDA probe, live Z calibration, Z-offset and temperature http://shop.prusa3d.com/forum/improvements-f14/pinda-probe-live-z-calibration-z-offset-and-temper-t2048.html So I got thinking on that and figured … Continue reading

Posted in Reprap 3D Printer | Tagged , , , , | Leave a comment

PLA vs ABS tough or not ?!

Source: http://forums.reprap.org/read.php?1,420767 Rigor_M [ PM ] PLA vs ABS tough or not ?! October 17, 2014 07:32AM Registered: 1 year ago Posts: 86 Ok, So I guess this topic was discussed multiple times on this forum but still, I can’t … Continue reading

Posted in Reprap 3D Printer, Science and technologies | Tagged , , , | Leave a comment