DIY tripod mount for GoPro Hero2

I got this idea from a Youtube video

I cut the mount base with a heated wood knife to prevent plastic dirt.
Then removed the melted plastic on the side of the mount base applying two sand papers, first was coarse one, then second was grade 1000 fine one.

Made a half inch long loop using a tape to secure the 1/4″ nut at the center of the base.

Covered the two long side holes of the base using a tape

Applied metal and plastic bonding material several times until it fills up all the low area around the mounting nut. I paid it 5,000 KRW (about $5 USD) which comes with two tubes, one is hardener, the other one is resin.

Camera model : Canon EOS DIGITAL REBEL XS
Date/Time : 2012:07:31 16:59:01
Resolution : 2602 x 3906
Flash used : No
Focal length : 25.0mm (35mm equivalent: 40mm)
CCD width : 22.25mm
Exposure time: 0.125 s (1/8)
Aperture : f/4.0
ISO equiv. : 200
Whitebalance : Manual
Metering Mode: pattern
Exposure : Manual
Exposure Mode: Manual

About janpenguin

Email: janpenguin [at] riseup [dot] net Every content on the blog is made by Free and Open Source Software in GNU/Linux.
This entry was posted in Photography and tagged , , , . Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s